Program 35 : SMDR Account Code Setup
35-02 : SMDR Output Options
Level:
IN
Description
Use Program 35-02 : SMDR Output Options to set the SMDR (Station Message Detail Recording)
output options for each of the eight SMDR ports. Refer to the following chart for a description of each
option, its range and default setting.
Input Data
SMDR Port Number 1 ~ 2
Item
No.
Item Input Data Description Default
01 Toll Restricted Call 0 = Not Displayed
1 = Displayed
SMDR can include or exclude calls
blocked by Toll Restriction.
1
02 PBX Calls 0 = Not Displayed
1 = Displayed
When the system is behind a PBX, SMDR
can include all calls (1) or just calls dialed
using the PBX trunk access code (0).
1
03 Trunk Number or
Name
0 = Name
1 = Number
Select whether the system should display
the trunk name (0) or the number (1) on
SMDR reports.
If this option is set to 1, Program
35-02-14 must be set to 0.
1
04 Summary (Daily) 0 = Not Displayed
1 = Displayed
Set this option to (1) to have the SMDR re-
port provides a daily summary (at midnight
every night).
1
05 Summary (Weekly) 0 = Not Displayed
1 = Displayed
Set this option to (1) to have the SMDR re-
port provides a weekly summary (every
Saturday at midnight).
1
06 Summary (Monthly) 0 = Not Displayed
1 = Displayed
Set this option to (1) to have the SMDR re-
port provides a monthly summary (at mid-
night on the last day of the month).
1
07 Toll Charge Cost 0 = Not Displayed
1 = Displayed
Set this option to (1) have the SMDR re-
port include toll charges.
1
08 Incoming Call 0 = Not Displayed
1 = Displayed
Enable this option (1) to have the SMDR
report include incoming calls. If you disa-
ble this option (0), incoming calls do not
print.
1
09 Extension Number or
Name
0 = Name
1 = Number
Set this option (1) to have the SMDR re-
port include extension numbers. Set this
option (0) to have the SMDR report include
extension names.
1
10 All Lines Busy (ALB)
Output
0 = Not Displayed
1 = Displayed
Determine if the All Lines Busy (ALB) indi-
cation should be displayed.
0
11 Walking Toll Restric-
tion Table Number
0 = Not Output
1 = Output
1
12 DID Table Name Out-
put
0 = Not Displayed
1 = Displayed
Determine if the DID table name should be
displayed.
0
ISSUE 6.0 SL1100
Programming Manual 2-351
Program
35
To Next Page
Loading...
