Program 90 : Maintenance Program
90-02 : Programming Password Setup
Level:
IN
Description
Use Program 90-02 : Programming Password Setup to set the system passwords. For password
entry, the system allows eight users to be defined. Each user can have a:
• Unique alphanumeric name (up to 10 alphanumeric characters)
• Password entry of up to eight digits (using 0 ~ 9, # and
)
• Password level
The IN level password is used by the System Installer for system programming. The SA or SB level
password cannot access the IN level programs. The reverse type (white on black) just beneath the
Description heading is the program access level. You can only use the program if your access level
meets or exceeds the level the program requires. (SA level password can access to SA or SB
programs, and SB level password can access to SB programs only.)
It is
NOT recommended to change these data. If you must change these Data
make sure you keep the ID/Password or you will never be able to enter the
program unless you clear all the System Data/Setting.
Input Data
User Number
1 ~ 8
Item
No.
Item Input Data Default
01 User Name Maximum 10 characters Refer below
02 Password Up to eight digits Refer below
03 User Level 0 = Prohibited User
2 = IN (Installer Level)
3 = SA (System Administrator Level 1)
4 = SB (System Administrator Level 2)
5 = UA (User Programming Administer Mode
Level 1)
Refer below
Default
User No.
User Name Password Level Level Description
1 necam
1 (MF) Manufacture Level - Access to all system
program
2 sltech 12345678 2 (IN) Installer Level - Access to all IN level pro-
grams.
3 ADMIN1 0000 3 (SA) System Administrator Level 1 - Restricted
Access
4 ADMIN2 9999 4 (SB) System Administrator Level 2 - More Re-
stricted Access
ISSUE 6.0 SL1100
Programming Manual 2-533
Program
90
To Next Page
Loading...
