NEC SL1100 - Page 152

Item
No.
Item Input Data Description Default Related
Program
58 Display mode of
trunk incoming
(V1.5 Deleted)
0 = Caller ID
1 = Memo Information
0 13-04-08
13-04-09
13-04-10
60 Soft Key/Naviga-
tion key Mode
0 = Standard Mode
1 = Advanced Mode1
2 = Advanced Mode2
2
61 Backlight Max
Brightness
0 ~ 8 6
62 Backlight Min
Brightness
0 ~ 8 0
63 Auto Backlight 0 = Off
1 = On
0 15-02-64
64 Auto Backlight
bound threshold
(auto setting)
0 ~ 13 13 15-02-63
65 Auto Backlight
bound threshold
(manual setting)
0 ~ 13 0
66 Dial Button
Backlight
0 = Off
1 = On
1
67 Caller ID shared
groups
0 = Personal
1 ~ 8 = Shared Group
0 20-49-01
68 Mode setting for
incoming call
from extension
Read Only:
0 = Voice
1 = Signal
This program can only be
change by using PC Program-
ming.
1
69 Mute Operation
on Handsfree
(3.0 Added)
0 = Do not change
Mute status
1 = Start with enabled
Mute
2 = Start with muted
Mute
0
70 Mute Key Opera-
tion (V2.0 Added)
0 = Enabled (Active)
1 = Disabled
This program determines whether
the Mute key is operational during a
call.
0
71 Disable Softkey
(V3.0 Added)
0 = Off
1 = On
When set to 1 (On), disable Softkey
and cursor key operation at the ter-
minal.
0
Lamp Cycle On/Off Timing Pattern (Program 15-02-35, 36, 38)
Programs 15-02-35, 36, and 38
Input Cycle
1 Cycle 1 500 ms - ON / 500 ms - OFF
2 Cycle 2 250 ms - ON / 250 ms - OFF
3 Cycle 3 125 ms - ON / 125 ms - OFF
4 Cycle 4 125 ms - ON / 125 ms - OFF / 125 ms - ON / 625 ms - OFF
5 Cycle 5 875 ms - ON / 125 ms - OFF
6 Cycle 6 625 ms - ON / 125 ms - OFF / 125 ms - ON / 125 ms - OFF
7 Cycle 7 1000 ms - ON
SL1100 ISSUE 6.0
2-132 Program 15 : Extension, Basic Setup
Program
15