EasyManua.ls Logo

NEC SL1100 - Page 589

NEC SL1100
650 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Program No. Name Default
20-13-01 Long Conversation Alarm 0
(Class 1 only)
20-13-22 Called Party Status 1
(Class 1 only)
20-09-04 Notification for Incoming Call List existence 0
(Class 1 only)
14-02-18 Busy tone detection on talking 1
(Trunks 1 ~ 27)
14-02-19 Busy tone detection frequency 3
(Trunks 1 ~ 27)
14-02-20 Busy tone detection interval 10
(Trunks 1 ~ 27)
80-04-06 ON Minimum RCV2 time 7
80-04-08 OFF Minimum RCV2 time 7
14-02-09 Busy tone detection 1
80-04-12 TONE RCV 2 frequency 1 1
(Table 1)
80-04-13 TONE RCV 2 frequency 2 2
(Table 2)
80-07-01 Call progress TONE detector frequency TABLE 1 set to 48
TABLE 2 set to 62
14-02-04 Flash For Timed Flash or Disconnect 0
(Trunks 1 ~ 27)
81-01-14 Flash (Hooking 1) 20
81-01-15 Flash (Hooking 2) 30
20-19-02 Caller ID Wait Timer 2
20-07-01 Manual Night Service Enabled 1
(Class 1 only)
25-03-01 DID/DISA Transfer Ring Group With Incorrect Dial-
ing
1
(Trunks 1 ~ 27 Mode 1)
25-04-01 DID/DISA Transfer Ring Group With No Answer/
Busy
1
(Trunks 1 ~ 27 Mode 1)
25-07-02 DID/DISA No Answer Time 16
25-07-11 DID/DISA Answer Delay Timer 3
32-02-01 Door Box Ring Assignment Set to EXT.101-108; DOOR 1; Mode 1-2
40-07-01 Voice Prompt Language Assignment for Voice
Mail
9
81-07-01 CODEC Filter Setup for Analog Trunk Ports 0
(Trunks 1 ~ 27)
25-07-03 Disconnect after DID/DISA re-transfer to IRG 180
20-02-11 Default Setting of Microphone of Key Telephone 0
24-02-03 Delayed Call Forwarding Time 16
14-02-02 Ring Detect Type This option to sets Extended
Ring Detect or Immediate Ring Detect for the
trunk
1
(Trunks 1 ~ 27)
20-07-11 Forced Trunk Disconnect (analog trunk only) Ena-
bles/disables an extension’s ability to use Forced
Trunk Disconnect
1
(Class 1 only)
20-03-04 Trunk Call Dial Sending Time by SLT 1
25-02-01 DID/DISA Talkie to assign the VRS message num-
ber
Trunks 1 ~ 27 Talkie = 1
Mode 1 data = 1 (Day Mode)
Mode 2 data = 2 (Night Mode)
ISSUE 6.0 SL1100
Programming Manual 2-569
Program
90

Table of Contents

Other manuals for NEC SL1100

Related product manuals