LAN Configuration
118
NETGEAR ProSAFE VPN Firewall FVS318G v2
3. In the upper right of the screen, select the IPv6 radio button.
4. Click the Add
table button.
5. Enter the settings as described in the following table.
6.
Click the Appl
y button.
Your changes are saved.
Table 26. Add IPv6 Static Routing screen settings
Setting Description
Route Name The route name for th
e static route (for purposes of identification and
management).
Active To make the static route effective, select the Active check box.
Note: A route can be added to the table and made inactive if not needed. This
allows you to use routes as needed without deleting and re-adding the entries.
IPv6 Destination The destination IPv6 address of the host or network to which the route leads.
IPv6 Prefix Length The destination IPv6 prefix length of the host or network to which the route leads.
Interface Select the physical or virtual network interface (WAN1, sit0 Tunnel, LAN, or DMZ
interface) through which the route is accessible.
IPv6 Gateway The gateway IPv6 address through which the destination host or network can be
reached.
Metric The priority of the route. Select a value between 2 and 15. If multiple routes to the
same destination exist, the route with the lowest metric is used.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
