Firewall Protection
139
NETGEAR ProSAFE VPN Firewall FVS318G v2
3. Click the Add table button under the Outbound Services table.
4. Enter the settings as described in T
able 29 on page 128.
In addition to selections from the Service, Action, and
Log lists, you must make
selections from the following lists:
• LAN Users
• WAN Users
Unless yo
ur selection from the Action list is BLOCK a
lways, you also must make
selections from the following lists:
• Sel
ect Schedule
• QoS Priority
• Bandwidth Profile
• NAT IP (This ist is available only when the
WAN mode is NAT. If you select Single
Address, the IP address specified must fall under the WAN subnet.)
5. Click the Ap
ply button.
Your changes are saved.
IPv6 LAN WAN Outbound Rules
To create an IPv6 LAN WAN outbound rule:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
To Next Page
Loading...
