Virtual Private Networking Using IPSec and L2TP Connections
230
NETGEAR ProSAFE VPN Firewall FVS318G v2
4. Specify the settings that are described in the following table.
5. T
o use the new settings immediately, click the Apply
button.
6. To keep the settings for future use, click the Save
button.
7. Click the Adv
anced tab in the Authentication pane.
Table 46. VPN client authentication settings
Setting Description
Interface Select Any from the list.
Remo
te Gateway Enter the remote IP address or DNS name of the VPN firewall. For example, enter
192.168.15.175.
Preshared Key Select the Preshared Key radio button. Enter the pre-shared key that you already
specified on the VPN firewall. For example, enter I7!KL39dFG_8. Confirm the key in
the Confirm field.
IKE Encryption Select the 3DES encryption algorithm from the list.
Authentication Select the SHA1 authentication algorithm from the list.
Key Group Select the DH2 (1024) key group from the list.
Note: On the VPN firewall, this key group is referred to as
Diffie-Hellman Group 2 (1024 bit).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
