Manage Users, Authentication, and VPN Certificates
303
NETGEAR ProSAFE VPN Firewall FVS318G v2
4. Click the By Source IP Address submenu tab.
5. In the upper right of the screen, select the IPv6
radio button.
6. In the Defined Addresses Status section, select one of the following
radio buttons:
• Deny Login from Defined Addresses.
Deny logging in from the IP addresses in the
Defined Addresses table.
• Allow Login only from Defined Addresses.
Allow logging in from the IP addresses
in the Defined Addresses table.
7. Click the Ap
ply button.
Your changes are saved.
8. In the Add Defined Addresses section, add an address to the Defined
Addresses table by
entering the settings as described in the following table:
9. Click the Ad
d table button.
The address is added to the Defined Addresses table.
10. Repeat St
ep 8 and Step 9 for any other addresses that you want to add to the Defined
Addresses table.
Table 70. Defined addresses settings for IPv6
Setting Description
Source Address Type Select the type of address fr
om the list:
• IP Address.
A single IPv6 address.
• IP Network.
A subnet of IPv6 addresses. You must enter a prefix length in the
Prefix Length field.
Network Address / IP
Address
De
pending on your selection from the Source Address Type list, enter the IP
address or the network address.
Prefix Length For a network address, enter the prefix length (0–64).
Note: By default, a single IPv6 address is assigned a prefix length of 64.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
