Default Settings and Technical Specifications
402
NETGEAR ProSAFE VPN Firewall FVS318G v2
Firewall and security settings
Inbound LAN WAN rules (communications coming in from
the Internet)
All traffic is blocked, except for traffic
in response to requests from the LAN.
Outbound LAN WAN rules (communications from the LAN
to the Internet)
All traffic is allowed.
Inbound and outbound DMZ WAN rules None
Inbound and outbound LAN DMZ rules None
Respond to ping on WAN (Internet) ports Disabled
Stealth mode Enabled
TCP flood Enabled
UDP flood Enabled
Respond to ping on LAN ports Disabled
IPv4 VPN pass-through for IPSec in NAT mode Enabled
IPv4 VPN pass-through for PPTP in NAT mode Enabled
IPv4 VPN pass-through for L2TP in NAT mode Enabled
IPv6 VPN pass-through for IPSec Enabled
Multicast pass-through for IGMP Disabled
Jumbo frames Disabled
Session limits Disabled
TCP time-out 1800 seconds
UDP time-out 120 seconds
ICMP time-out 60 seconds
SIP ALG Disabled
Source MAC filtering Disabled
IP/MAC bindings Disabled
Port triggering rules None
UPnP Disabled
Bandwidth profiles None
Table 86. VPN firewall factory default configuration settings (continued)
Feature Default Behavior
To Next Page
Loading...
Need help?
General
Weight and Dimensions
