Nokia 7210 SAS-Mxp - Page 142

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Figure 9: System initialization: TiMOS boot
4.2.2 BOF chassis-role and host-type parameters for 7210 SAS-Mxp, 7210 SAS-Sx
1/10GE, 7210 SAS-S 1/10GE, and 7210 SAS-Sx 10/100GE
On the 7210 SAS-Mxp, 7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE, and 7210 SAS-Sx 10/100GE, the
operator can configure the chassis-role and host-type boot parameters to operate the 7210 SAS node
in standalone mode or satellite mode. The values configured for these parameters must be consistent
for boot up to proceed correctly. Table 21: 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, and 7210 SAS-Sx
10/100GE boot loader actions for chassis-role and host-type parameters describes the boot loader action
when the chassis-role and host-type parameters are set to one of the allowed values.
The bof>host-type command can be set to one of the following values:
• none (factory default setting)
• standalone
• satellites
The chassis-role boot parameter (not available in the BOF) can be set to one of the following values:
• factory-default
By default, the chassis-role boot parameter value is set to factory-default when the 7210 SAS-Sx
1/10GE, 7210 SAS-S 1/10GE, 7210 SAS-Sx 10/100GE and 7210 SAS-Mxp are shipped from the
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
142
SPACER TEXT