EasyManua.ls Logo

Nokia 7210 SAS-Mxp - System Resource Profile Commands for MAC Authentication; Global System Resource Profile Commands for 7210 SAS-R6 and 7210 SAS-R12

Nokia 7210 SAS-Mxp
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
crossing event will also be generated if the first sample taken is greater than or equal to
this threshold and the associated startup-alarm is equal to rising or either.
After a rising threshold crossing event is generated, another such event will not be
generated until the sampled value falls below this threshold and reaches less than or equal
the falling threshold value.
Values –2147483648 to 2147483647
Default 0
falling-event rmon-event-id
Specifies the action to be taken when a falling threshold crossing event occurs. If there is
no corresponding event configured for the specified rmon-event-id, then no association
exists and no action is taken. If the falling-event has a value of zero (0), no associated
event exists.
If a falling event is configured, the CLI requires a falling-threshold to also be configured.
Values –2147483648 to 2147483647
Default 0
falling-threshold threshold
Specifies a threshold for the sampled statistic. A single threshold crossing event is
generated when the current sampled value is less than or equal to this threshold, and
the value at the last sampling interval was greater than this threshold. A single threshold
crossing event will also be generated if the first sample taken is less than or equal to this
threshold and the associated startup-alarm is equal to falling or either.
After a rising threshold crossing event is generated, another such event will not be
generated until the sampled value rises above this threshold and reaches greater than or
equal the rising-threshold value.
Values –2147483648 to 2147483647
Default 0
owner owner
Specifies the owner. The owner identifies the creator of this alarm. It defaults to ‟TiMOS
CLI”. This parameter is defined primarily to allow entries that have been created in the
RMON-MIB alarmTable by remote SNMP managers to be saved and reloaded in a CLI
configuration file. The owner will not normally be configured by CLI users and can be a
maximum of 80 characters.
Default TiMOS CLI
event
Syntax
event rmon-event-id [event-type] [description description-string] [owner owner-string]
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
388
SPACER TEXT

Table of Contents

Related product manuals