EasyManua.ls Logo

Nokia 7210 SAS-Mxp - Configuration Example to Use PTP and Synce References on 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1;10 GE, and 7210 SAS-T

Nokia 7210 SAS-Mxp
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
6.14.1.3.4.2 Peer
Configuration of an NTP peer configures symmetric active mode for the configured peer. Although any
system can be configured to peer with any other NTP node, Nokia recommends to configure authentication
and to configure known time servers as their peers. Use the no form of the command to remove the
configured peer.
Use the following CLI syntax to configure symmetric active mode.
config>system>time>ntp
peer ip-address [version version][key-id key-id]
[prefer]
Example: Command usage to configure symmetric active mode
config>system>time>ntp#
config>system>time>ntp# peer 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
Example: Configuration output
The following is a sample configuration output of NTP enabled with the peer command configured.
A:sim1>config>system>time>ntp# info
----------------------------------------------
no shutdown
peer 192.168.1.1 key-id 1
----------------------------------------------
A:sim1>config>system>time>ntp#
6.14.1.3.4.3 Server
The server command is used when the node should operate in client mode with the NTP server specified
in the address field. Use the no form of this command to remove the server with the specified address from
the configuration. Up to five NTP servers can be configured.
Use the following CLI syntax to configure the node to operate in client mode.
config>system>time>ntp
server {ip-address |ptp}[key-id key-id] [version version] [prefer]
Example: Command usage
The following example shows the command usage to configure the node to operate in client mode.
config>system>time>ntp#
config>system>time>ntp# server 192.168.1.1 key-id 1
config>system>time>ntp# no shutdown
Example: Configuration output
The following is a sample configuration of NTP enabled with the server command configured.
A:7210SAS>config>system>time>ntp# info
----------------------------------------------
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
302
SPACER TEXT

Table of Contents

Related product manuals