7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
vc-stack-node
Syntax
vc-stack-node slot-number mac-address mac-address [create]
no vc-stack-node slot-number
Context
config>system>vc-stack
Platforms
7210 SAS-Sx 1/10GE (standalone-VC) and 7210 SAS-S 1/10GE (standalone-VC)
Description
This command configures an IMM-only node in a virtual chassis (VC) configuration. This command is
performed on the active CPM node in the VC to which the IMM-only node belongs.
An IMM-only node in a VC is identified by its slot-number and its MAC address. The slot number assigned
to the node can be an arbitrary number from 1 to 8. It is used in service provisioning to identify ports on
a VC member node, and on service objects on those ports. The port on a VC member node is identified
using the format slot-id/1/port-id. For example, port 20 on the front panel of a VC member node in slot 4 is
identified as 4/1/20; SAPs configured on those ports are identified as 4/1/20:300.
Slot numbers are unique to each VC which are identified by their vc-stack-node, and can be reused
across different VCs. The software ensures the uniqueness of the slot number in each VC by raising an
error if two nodes in the same VC are assigned the same slot number.
The MAC address used for VC configuration is the chassis MAC address printed on the label of the node.
The MAC address of the IMM-only node is also visible using the console connection.
When an IMM-only node boots up, it uses the MAC address and slot number received in the VC discovery
messages sent by the CPM node so that it can boot up in VC mode.
The no form of this command removes the IMM-node from the VC.
Parameters
slot-number
Specifies the slot assigned to an IMM-only node in a VC.
Values 1 to 8
create
Keyword to create the node in a VC.
mac-address
Specifies the chassis MAC address of the IMM-only node.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
373
SPACER TEXT
To Next Page
Loading...