Nokia 7210 SAS-Mxp - Debug Commands

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:32:04 IST 2011 by builder in /builder/3.0B5/panos/main
Login:
Step 7. At the prompt, enter admin for the default username and password, and log in to the 7210 SAS
device.
7.2 Procedures to boot using manual mode
Note:
The manual mode is supported on all 7210 SAS platforms, except those operating in satellite
mode.
This section describes the procedures to boot the 7210 SAS from the network or flash using the manual
mode.
The manual mode can be used to boot the 7210 SAS device in the following scenarios:
• user boots the device for the first time
• user boots the device after a reset to the factory default settings, or after executing the admin>reboot
auto-init command (this command is not supported on the 7210 SAS-R6 and 7210 SAS-R12, and
7210 SAS platforms configured in the standalone-VC mode of operation)
In all scenarios, the user must create a local BOF by connecting a console to the node and interrupting the
boot process to configure the BOF parameters. The following sections provide the details for configuring
the BOF parameters under different scenarios.
The manual mode has two options:
• 7210 SAS device is booted from the local image on flash; see section Procedure to boot from the image
on flash in manual mode (supported on all 7210 SAS platforms, except those operating in the satellite
mode)
• 7210 SAS device is booted from the network using an uplink port (section Procedure to boot from
the network in manual mode using uplink ports; supported on all 7210 SAS platforms, except the
7210 SAS-R6 and 7210 SAS-R12) or the Ethernet management port (section Procedure to boot from
the network in manual mode using the OOB Ethernet management port; supported on all 7210 SAS
platforms when the Ethernet management port is available)
7.2.1 Procedure to boot from the image on flash in manual mode
About this task
Note:
This procedure is not supported for 7210 SAS platforms configured in the satellite mode of
operation.
7210 SAS platforms that are factory-shipped with the boot.tim and both.tim (TiMOS image) on the
internal flash attempt to boot using the auto-init mode when they are booted for the first time from factory.
If the auto-init mode fails, the node loads with the image on the flash. If the user wants to continue using
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
680
SPACER TEXT