Nokia 7210 SAS-Mxp - Configuring System Monitoring Thresholds; Creating Events

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
location
Syntax
location location
no location
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command creates a text string that identifies the system location for the device.
Only one location can be configured. If multiple locations are configured, the last one entered overwrites
the previous entry.
The no form of this command reverts to the default value.
Parameters
location
Specifies the location as a character string. The string may be up to 80 characters. Any
printable, seven-bit ASCII characters can be used within the string. If the string contains
special characters (#, $, spaces, and so on), the entire string must be enclosed within
double quotes.
login-control
Syntax
login-control
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
Commands in this context configure login control.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
360
SPACER TEXT