Nokia 7210 SAS-Mxp - Procedure to Boot from the Network in Manual Mode Using the OOB Ethernet Management Port

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Loading image uf1:\both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312) + data:(7133216-->49945144)
Executing TiMOS image at 0x2800000
Step 4. The system loads the TiMOS image and the 7210 SAS device boots up. The following console
output is displayed.
Example
Total Memory: 2GB Chassis Type: 0xa Card Type: 0x43
TiMOS-B-20.3.B1-1 both/hops Nokia SAS-Sx 64SFP+4CFP4 7210 Copyright (c) 2000-
2020 Nokia.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/20.3B1/panos/
main
Running 32 bit architecture
Time from clock is WED MAR 04 11:19:24 2020 UTC
Login:
Step 5.
At the prompt, enter admin for the default username and password, and log in to the 7210 SAS
device.
7.4 Procedure to boot in the satellite mode
About this task
Note:
See Table 1: Supported modes of operation and configuration methods for the list of 7210 SAS
platforms that support the satellite mode of operation.
See System boot options for 7210 SAS-Mxp, 7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE, and
7210 SAS-Sx 10/100GE in satellite mode for information about the satellite mode on 7210 SAS
devices.
See the specific 7210 SAS chassis installation guide for more information about prerequisites to boot the
system in the satellite mode of operation.
Perform the following steps to boot the 7210 SAS device in the satellite mode of operation.
Procedure
Step 1.
Configure the 7750 SR host with the 7210 SAS both.tim image location (the software
repository).
a. Create the software repository to store the images by using the software-repository
command:
Example
*A:dut-h# configure system software-repository ‟7210-SAS-Sx-9.0R7-Images” create
b. Provide a description for the software repository by using the description command:
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
700
SPACER TEXT