7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
20.3B1/panos/main
text:(13818400-->40990080) + data:(3162656-->19580220)
Starting at 0x18000000...
Total Memory: 2GB Chassis Type: 0xa Card Type: 0x43
TiMOS-L-20.3.B1-1 boot/hops Nokia SAS-Sx 64SFP+4CFP4 7210 Copyright (c) 2000-
2020 Nokia.
All rights reserved. All use subject to applicable license agreements.
Built on Wed Feb 12 15:31:09 IST 2020 by sasbuild in /home/sasbuild/20.3B1/panos/
main
TiMOS BOOT LOADER
Time from clock is WED MAR 04 11:18:16 2020 UTC
Switching serial output to sync mode... done
Chassis-role is set to : standalone
Looking for uf1:/bof.cfg ... OK, reading
Step 2. The system locates the BOF on a local drive. The system reads the contents of the BOF and
displays it on the console.
The following console output is displayed.
Example
Contents of Boot Options File on uf1:
primary-image uf1:\both.tim
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/67
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/68
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
Hit a key within 1 second to change boot parameters...
Step 3. At the prompt, wait until the specified wait time has elapsed. The boot process can be interrupted
at the prompt if necessary to change the boot parameters (for example, the image location). In
this example, it is assumed that changes to the BOF are not required.
The following console output is displayed.
Example
Configuring Network with uplinkA Port Setting.....
No existing config file URL
Primary image location: uf1:\both.tim
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
699
SPACER TEXT
To Next Page
Loading...