7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
The number of nodes specified indicates the number of higher-level contexts that can be displayed in the
prompt. For example, if reduced-prompt is set to 2, the two highest contexts from the present working
context are displayed by name with the hidden (reduced) contexts compressed into a ellipsis (‟…”).
The following is a sample configuration output.
A:ALA-1>environment# reduced-prompt 2
A:ALA-1>vonfig>router# interface to-103
A:ALA-1>...router>if#
The setting is not saved in the configuration. It must be reset for each CLI session or stored in an exec
script file.
The no form of the command reverts to the default.
Default
no reduced-prompt
Parameters
no of nodes in prompt
Specifies the maximum number of higher-level nodes displayed by name in the prompt,
expressed as a decimal integer.
Default 2
Values 0 to 15
saved-ind-prompt
Syntax
[no] saved-ind-prompt
Context
environment
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command enables saved indicator in the prompt. When changes are made to the configuration file a
‟*” appears in the prompt string indicating that the changes have not been saved. When an admin save
command is executed, the ‟*” disappears.
The following is a sample configuration output.
*A:ALA-48# admin save
Writing file to ftp://xxx.xxx.xx.xx/./sim48/sim48-config.cfg
Saving configuration .... Completed.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
74
SPACER TEXT
To Next Page
Loading...