Nokia 7210 SAS-Mxp - CLI Usage; CLI Structure; Navigating in the CLI; CLI Contexts

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Getting started
Table 3: 7210 SAS platforms supporting port modes
Port ModePlatform
Access Network Hybrid Access-
uplink
7210 SAS-D Yes No No Yes
7210 SAS-Dxp Yes No No Yes
7210 SAS-K 2F1C2T Yes No No Yes
7210 SAS-K 2F6C4T Yes Yes Yes Yes
7210 SAS-K 3SFP+ 8C Yes Yes Yes Yes
7210 SAS-Mxp Yes Yes Yes No
7210 SAS-R6 IMM-b
(IMMv2)
Yes Yes Yes No
7210 SAS-R6 IMM-c
100GE (IMM-c 1CFP4 or
IMM-c 1QSFP28)
Yes Yes Yes No
7210 SAS-R12 IMM-b Yes Yes Yes No
7210 SAS-R12 IMM-c
100GE (IMM-c 1CFP4 or
IMM-c 1QSFP28)
Yes Yes Yes No
7210 SAS-Sx/S 1/10GE Yes Yes Yes No
7210 SAS-Sx 10/100GE Yes Yes Yes No
7210 SAS-T Yes
Yes
6
Yes
7
Yes
8
1.4 7210 SAS system configuration process
The following table lists the tasks necessary to configure boot option files (BOF) and system and file
management functions. Each chapter in this book is presented in an overall logical configuration flow. Each
section describes a software area and provides CLI syntax and command usage to configure parameters
for a functional area. After the hardware installation has been properly completed, proceed with the
7210 SAS-Series device configuration tasks in the following order:
6
Network ports are supported only if the node is operating in network mode.
7
Hybrid ports are supported only if the node is operating in network mode.
8
Access-uplink ports are supported only if the node is operating in access-uplink mode.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
25
SPACER TEXT