7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Getting started
SAPs, which are QinQ SAPs, can only be configured on an access-uplink port to allow the operator to
differentiate multiple services being carried over a single uplink port.
This is the default port mode of a 7210 SAS node in the access-uplink mode of operation.
• network port mode
Network ports are configured for network-facing traffic in the service provider transport or infrastructure
network, and provide IP/MPLS uplinks.
This is the default port mode of a 7210 SAS node in the network or standalone mode of operation.
• hybrid port mode
Hybrid ports are configured for access and network facing traffic, and allow a single port to operate in
both access and network modes.
Port modes available for configuration on a 7210 SAS node are determined by the current mode of
operation of the router.
Note:
The 7210 SAS-K 2F6C4T and 7210 SAS-K 3SFP+ 8C are unique; all port modes listed in Table
2: Supported port modes by mode of operation are available for configuration on the router,
regardless of the current mode of operation.
The following table lists the port mode configuration support per 7210 SAS mode of operation.
Table 2: Supported port modes by mode of operation
Supported Port ModeMode of Operation
Access Network Hybrid Access-
uplink
Access-Uplink
✓ ✓
Network
✓ ✓ ✓
Satellite
5
Standalone
✓ ✓ ✓
Standalone-VC
✓ ✓ ✓
The following table lists the port mode configuration supported by the 7210 SAS product family. See the
appropriate Interface Configuration Guide for more information about configuring the port modes for a
specific platform.
5
Port modes are configured on the 7750 SR host and managed by the host.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
24
SPACER TEXT
To Next Page
Loading...