7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Context
config>system>ip
Platforms
7210 SAS-Mxp
Description
This command enables CPU-based IP fragmentation. When allow-cpu-fragmentation is enabled, the
CPM extracts oversized IPv4 packets from the datapath, fragments them using the system CPU, and
inserts the fragmented packets back into the datapath. See the 7210 SAS-Mxp, R6, R12, S, Sx, T Router
Configuration Guide for more information about IP fragmentation.
The no form of this command disables CPU-based IP fragmentation.
Default
no allow-cpu-fragmentation
lacp-system-priority
Syntax
lacp-system-priority lacp-system-priority
no lacp-system-priority
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the Link Aggregation Control Protocol (LACP) system priority on aggregated
Ethernet interfaces. LACP allows the operator to aggregate multiple physical interfaces to form one logical
interface.
Default
32768
Parameters
lacp-system-priority
Specifies the LACP system priority.
Values 1 to 65535
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
359
SPACER TEXT
To Next Page
Loading...