7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Note:
The SYS LED is green after the device has successfully completed the boot process
and is running normally.
7.2.2 Procedure to boot from the network in manual mode using uplink ports
About this task
Note:
This procedure is supported on all 7210 SAS platforms, except the 7210 SAS-R6 and 7210 SAS-
R12, and all platforms configured in the satellite mode of operation.
Perform this procedure to boot a 7210 SAS device from the network without using the auto-init mode.
Note:
See the corresponding 7210 SAS chassis installation guide for information about equipment
required to setup the device.
The front panel ports (referred to as uplinkA and uplinkB in the sample output used in this procedure) are
used to boot the device from the network.
Note:
Nokia recommends that the TiMOS image should be stored on the internal flash so that it
is available for use in the case where booting the system from the flash is required later on
subsequent reboot.
Perform the following steps to boot from the network in the manual mode using uplink ports.
Procedure
Step 1. Power on the 7210 SAS device.
Step 2. Use the uplink ports to boot from the network.
Example
Nokia SASDxp 7210 Boot ROM. Copyright 2000-2020 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Build: X-20.3.B1-1 on Wed Feb 12 15:29:18 IST 2020 by sasbuild
Version: 0x8
SASDxp-DC Board
Shmoo tuning data in flash is valid, load it
DDR Tuning Complete.
Passed!
Copying code from FLASH to RAM....
Done
Board CPLD Version: 0x0e
Reboot Reason: 0x05
Boot rom version is v8
>>> RAM: Testing DDR Passed!
Board Serial Number is 'NS1917T0023'
DDR Tuning Complete.
Tuning values already saved. Skip saving to flash.
Memory Test Passed!
Jumping to vxrom at 0x61400000 now..................
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
685
SPACER TEXT
To Next Page
Loading...