Nokia 7210 SAS-Mxp - Page 684

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
:
Step 9. At the prompt, press Enter. The following console output is displayed.
Example
New Settings
------------
primary-image cf2:/both.tim
primary-config uf1:/sassx64.cfg
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/65
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/66
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Step 10.
At the prompt, enter yes. The 7210 SAS device begins to boot with the new settings. The
following console output is displayed.
Example
Successfully saved the new settings in cf1:/bof.cfg
Configuring Network with uplinkA Port Setting.....
Primary config file present at: uf1:/sassx64.cfg
Skipping missing or bad Sap index file 'uf1:/sassx64.sdx'
Primary image location: cf2:/both.tim
Loading image cf2:\both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312) + data:(7133216-->49945144)
Executing TiMOS image at 0x2800000
Step 11. After the 7210 SAS device boots up, the following login prompt is displayed.
Example
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 14:32:04 IST 2011 by builder in /builder/3.0B5/panos/main
Login:
Step 12.
At the prompt, enter admin for the default username and password, and log into the 7210 SAS
device.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
684
SPACER TEXT