Nokia 7210 SAS-Mxp - 7210 SAS Port Modes

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Getting started
1.1.1 Document structure and content
This guide uses the following structure to describe features and configuration content.
Note:
This guide generically covers Release 22.x.Rx content and may include some content that will be
released in later maintenance loads. See the 7210 SAS Software Release Notes 22.x.Rx, part
number 3HE 18217 000x TQZZA, for information about features supported in each load of the
Release 22.x.Rx software.
• This guide is organized into functional chapters and provides concepts and descriptions of the
implementation flow. Each chapter describes a software area and provides CLI syntax and command
usage to configure parameters for the functional area.
• Command outputs shown in this guide are examples only; actual displays may differ depending on
supported functionality and user configuration.
• See the 7210 SAS-Mxp, R6, R12, S, Sx, T Basic System Configuration Guide for boot options to
configure the satellite mode of operation on the router. See the 7750 SR software user guides for
information about service and protocol provisioning, and operating the 7210 SAS router in satellite
mode.
• Unless explicitly noted, the CLI commands and their configuration is similar for both network and
access-uplink operating modes for features applicable to both modes of operation.
1.2 7210 SAS modes of operation
Unless explicitly noted, the phrase ‟mode of operation” and ‟operating mode” refers to the current
operating mode of the 7210 SAS router. Each operating mode provides configuration access to a specific
group of CLI commands.
Note:
Not all CLI commands are supported on all 7210 SAS platforms in all modes of operation. Users
can only configure CLI commands supported by the current operating mode of the router. See
the 7210 SAS Software Release Notes 22.x.Rx, part number 3HE 18217 000x TQZZA, and to
the appropriate 7210 SAS software user guide for information about features and capabilities
supported by a 7210 SAS platform when operating in a specific mode.
The following modes of operation are supported by the 7210 SAS product family.
• access-uplink
In the access-uplink operating mode, the 7210 SAS router uplinks to the network using Layer 2 Ethernet
VLAN switching (without IP/MPLS).
Platforms Supported: 7210 SAS-D, 7210 SAS-Dxp, 7210 SAS-K 2F1C2T, 7210 SAS-K 2F6C4T,
7210 SAS-K 3SFP+ 8C, and 7210 SAS-T
• network
In the network operating mode, the 7210 SAS router uses IP/MPLS uplinks to the network. The IP
routing protocols and MPLS functionality is available; see the appropriate 7210 SAS software user
guide for more information about supported features.
Platforms Supported: 7210 SAS-K 2F6C4T, 7210 SAS-K 3SFP+ 8C, 7210 SAS-Mxp, 7210 SAS-R6,
7210 SAS-R12, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, and 7210 SAS-T
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
21
SPACER TEXT