Nokia 7210 SAS-Mxp - Procedure to Boot When the BOF Is Present Locally

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Example
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Waiting for 30 seconds to enter password
Password:
Step 5.
At the prompt, enter the default password password, and initiate the BOF edit.
The system accepts the password and the following console output is displayed.
Example
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"diag" - enter the diag shell.
"reset" - reset the bof and reboot.
Press ENTER to begin, or 'flash' to enter firmware update...
Step 6. At the prompt, press Enter to edit the BOF. The following console output is displayed.
Chassis-Role
-------------
Current chassis-role is : standalone
You can change it to { satellite | standalone-vc | factory-default }.
Press ENTER to continue OR "edit" to change the chassis-role : standalone-vc
Press "edit" to change OR ENTER to continue :
Step 7.
At the prompt, enter edit. The following console output is displayed.
Example
Enter the new chassis-role { satellite | standalone-vc | factory-
default } :
Step 8.
At the prompt, enter standalone-vc for the chassis-role. The following output is displayed.
Example
Are you sure you want to set the chassis-role as standalone-vc? (yes/no) :
Step 9.
At the prompt, enter yes. The following console output is displayed.
Example
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
707
SPACER TEXT