7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
7210 SAS-R6 and 7210 SAS-R12
Description
This command removes resources allocated to port-based and IP interface-based network ingress QoS
policies associated with network and hybrid ports, and makes the resources available for other features
that share the ingress-internal-tcam resource pool (for example, SAP ingress classification and ingress
ACLs).
Note:
• The minimum num-resources configurable is 0 and the maximum num-resources configurable
is 2. The default num-resources is 2 for the default system resource profile and user-
configured system resource profile. A value of 1 is not allowed.
• If the user configures the value 2, one slice is allocated to the network QoS policy IP interface,
and one slice is allocated to the network QoS policy port.
• A reboot is not required after assigning a new value to the qos-network-ingress-resource
command. That is, the value of this command can be changed from 0 to 2 if there are
resources available in the ingress-internal-tcam pool. Similarly, the value can be changed
from 2 to 0 if no network or hybrid ports are configured. If a network port or hybrid port is
configured, changing the value from 2 to 0 is fails and the system sends an error message.
The no form of this command reverts to the default value.
Default
qos-network-ingress-resource 0
Parameters
num-resources
Specifies the number of resources allocated to network ingress QoS policy queues.
Values 0, 2, def
qos-sap-ingress-resource
Syntax
qos-sap-ingress-resource num-resources
no qos-sap-ingress-resource
Context
configure>system>resource-profile>ing-internal-tcam
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
547
SPACER TEXT
To Next Page
Loading...