Nokia 7210 SAS-Mxp - Page 546

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
access port ingress QoS policy to 0) is not allowed. Resources allocated to access ingress QoS policies
are used to allocate meter resources for the port-based access ingress QoS policy.
Note:
On the 7210 SAS-Sx 10/100GE, the sum of resources, also called slices, allocated to SAP
ingress policies using the config>system>resource-profile>ingress-internal-tcam>qos-sap-
ingress-resource command and to access ingress policies using the config>system>resource-
profile>ingress-internal-tcam>qos-access-port-ingress-resource command must not exceed
3.
The no form of this command reverts to the default value.
Default
qos-access-port-ingress-resource 0
Parameters
num-resources
Specifies the amount of resources allocated to QoS access port ingress policies.
Values The following table lists the number of resources that can be allocated
to QoS access port ingress policies per 7210 SAS platform.
Table 59: Number of resources allocated to QoS access port
ingress policies on 7210 SAS platforms
7210 SAS platform Number of resources
7210 SAS-Mxp 0 to 4
7210 SAS-R6 IMM-b 0 to 3
7210 SAS-R6 IMM-c 0 to 1
7210 SAS-R12 0 to 3
7210 SAS-Sx/S 1/10GE 0 to 7
7210 SAS-Sx 10/100GE 0 to 2
qos-network-ingress-resource
Syntax
qos-network-ingress-resource num-resources
no qos-network-ingress-resource
Context
config>system>res-prof>ing-internal-tcam
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
546
SPACER TEXT