Nokia 7210 SAS-Mxp - Show Commands

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
characters (#, $, spaces, and so on), the entire string must be enclosed within double
quotes.
owner owner
Specifies the creator of this alarm. This parameter is defined primarily to allow entries that
have been created in the RMON-MIB alarmTable by remote SNMP managers to be saved
and reloaded in a CLI configuration file. The owner will not normally be configured by CLI
users and can be a maximum of 80 characters.
Default TiMOS CLI
6.20.2.1.5 PTP commands
ptp
Syntax
ptp
Context
config>system
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE (standalone), 7210 SAS-Sx
10/100GE 64SFP+ 4QSFP28 (standalone), 7210 SAS-T (network and access-uplink)
Description
Commands in this context configure parameters for IEEE 1588-2008, Precision Time Protocol.
anno-rx-timeout
Syntax
anno-rx-timeout count
no anno-rx-timeout
Context
config>system>ptp
Platforms
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE (standalone), 7210 SAS-Sx
10/100GE 64SFP+ 4QSFP28 (standalone), 7210 SAS-T (network and access-uplink)
Description
This command configures the PTP announce receipt timeout count in the Announce message.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
390
SPACER TEXT