Nokia 7210 SAS-Mxp - Configuration to Change Reference from Synce to PTP on 7210 SAS-M

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Use the following CLI syntax to transmit broadcast packets.
config>system>time>ntp
broadcast [router router-name]{interface
ip-int-name}[key-id key-id] [version version][ttl ttl]
Example: Command usage to transmit broadcast packets
config>system>time>ntp#
config>system>time>ntp# broadcast interface int11 version 4
ttl 127
config>system>time>ntp# no shutdown
Example: Configuration output in the system>time context
The following sample configuration of the system>time context shows NTP enabled with the broadcast
command configured.
A:sim1>config>system>time# info detail
----------------------------------------------
ntp
no shutdown
authentication-check
ntp-server
broadcast interface int11 version 4 ttl 127
exit
A:sim1>config>system>time#
Example: Configuration output in the config context
The following sample configuration shows NTP enabled in the config context with the broadcast
command configured. At this level, the NTP broadcast commands are displayed at the end of the output
after the router interfaces are shown.
A:sim1>config info
....
#--------------------------------------------------
echo "System Time NTP Configuration"
#--------------------------------------------------
system
time
ntp
broadcast interface toboth
exit
exit
exit
A:sim1>config
6.14.1.3.4 Broadcastclient
The broadcastclient command enables listening to NTP broadcast messages on the specified interface.
Use the following CLI syntax to enable listening to NTP broadcast messages.
config>system>time>ntp
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
300
SPACER TEXT