Nokia 7210 SAS-Mxp - Page 301

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
broadcastclient[router router-name] {interface ip-int-name} [authenticate]
Example: Command usage to enable listening to NTP broadcast messages
config>system>time>ntp#
config>system>time>ntp# broadcastclient interface int11
config>system>time>ntp# no shutdown
Example: Configuration output
The following is a sample configuration of NTP enabled with the broadcastclient parameter enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
ntp
broadcastclient interface int11
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone UTC
----------------------------------------------
A:ALA-12>config>system>time#
6.14.1.3.4.1 NTP-server
This command configures the node to assume the role of an NTP server. Unless the server command is
used, this node will function as an NTP client only and will not distribute the time to downstream network
elements. If an authentication key-id is specified in this command, the NTP server requires client packets
to be authenticated.
Use the following CLI syntax to configure the node to function as an NTP client only.
config>system>time>ntp
ntp-server [transmit key-id]
Example: Command usage
The following example shows the command usage to configure the node to function as an NTP client only.
config>system>time>ntp#
config>system>time>ntp# ntp-server transmit 1
config>system>time>ntp# no shutdown
Example: Configuration output
The following is a sample configuration output of NTP enabled with the ntp-server command configured.
A:sim1>config>system>time>ntp# info
----------------------------------------------
no shutdown
ntp-server
----------------------------------------------
A:sim1>config>system>time>ntp#
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
301
SPACER TEXT