7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
both — Both an entry in the RMON-MIB logTable and a TiMOS logger
event are generated.
none — No action is taken.
Default both
startup-alarm alarm-type
Specifies the alarm that may be sent when this alarm is first created. If the first sample is
greater than or equal to the rising threshold value and startup-alarm is equal to rising or
either, a single rising threshold crossing event is generated. If the first sample is less than
or equal to the falling threshold value and startup-alarm is equal to falling or either, a
single falling threshold crossing event is generated.
Values rising, falling, either
Default either
cflash-cap-alarm
Syntax
cflash-cap-alarm cflash-id rising-threshold threshold [falling-threshold threshold] interval seconds
[rmon-event-type] [startup-alarm alarm-type]
no cflash-cap-alarm cflash-id
Context
config>system>thresholds
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command enables capacity monitoring of the compact flash specified in this command. The severity
level is alarm. Both a rising and falling threshold can be specified.
The no form of this command removes the configured compact flash threshold alarm.
Parameters
cflash-id
Specifies the name of the cflash device to be monitored.
Values cf1:, cf2:, uf1: (7210 SAS-T, 7210 SAS-Sx 1/10GE: standalone and
standalone-VC, 7210 SAS-Sx 10/100GE, and 7210 SAS-Mxp)
cf2:, cf2-A:, cf2-B:, uf1:, uf1-A:, uf1-B: (7210 SAS-R6 and 7210 SAS-
R12)
cf1:, cf2: (7210 SAS-S 1/10GE: standalone and standalone-VC)
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
378
SPACER TEXT
To Next Page
Loading...