7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
2.9.2.1 Global commands
enable-admin
Syntax
enable-admin
Context
<global>
Description
Note:
See the description for the admin-password command. If the admin-password is configured
in the config>system>security>password context, any user can enter a special administrative
mode by entering the enable-admin command.
The enable-admin command is in the default profile. By default, all users are given access to this
command.
When the enable-admin command is entered, the user is prompted for a password. If the password is
correct, the user is given unrestricted access to all commands.
The minimum length of the password is determined by the minimum-length command. The complexity
requirements for the password is determined by the complexity command.
The following is an example of a password configuration.
A:ALA-1>config>system>security# info
----------------------------------------------
...
password
aging 365
minimum-length 8
attempts 5 time 5 lockout 20
admin-password "rUYUz9XMo6I" hash
exit
...
----------------------------------------------
A:ALA-1>config>system>security#
Use one of the following options to verify that a user is in the enable-admin mode.
• Administrators cab use the show users command to know which users are in this mode.
• Enter the enable-admin command again at the root prompt and an error message will be returned.
The following is an example output for the show users command.
A:ALA-1# show users
===============================================================================
User Type From Login time Idle time
===============================================================================
admin Console -- 10AUG2006 13:55:24 0d 19:42:22
admin Telnet 10.20.30.93 09AUG2004 08:35:23 0d 00:00:00 A
-------------------------------------------------------------------------------
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
53
SPACER TEXT
To Next Page
Loading...