Nokia 7210 SAS-Mxp - Save; Reboot

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
The operational state of the entity is disabled as well as the operational state of any entities contained
within. Many objects must be shut down before they may be deleted.
The no form of this command places the entity into an administratively enabled state.
Default
no shutdown
Special Cases
PTP Protocol Handling
Applies only to 7210 SAS-Mxp. When the no shutdown command is issued in
the configure>system>ptp context, resources are allocated to enable processing
of the protocol by the node. When the shutdown command is issued in the
configure>system>ptp context, the resources are deallocated.
Note:
Resources for PTP are allocated when the protocol is enabled in the base
routing instance. Resources are deallocated when the configuration of the
last PTP context under the base routing instance is shutdown
description
Syntax
description description-string
no description
Context
config>system>cron>sched
config>system>cron>time-range
config>system>cron>tod-suite
config>system>script-control>script
config>redundancy>multi-chassis>peer
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
Note:
The config>redundancy>multi-chassis>peer context is not supported on 7210 SAS platforms
configured in the access-uplink operating mode
This command creates a text description stored in the configuration file for a configuration context.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
350
SPACER TEXT