7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
You will be asked to configure the port number, IP(v6) address,
static routes, and VLAN Id in case of uplink ports.
Existing uplinkA port settings are:
uplinkA-port 1/1/11
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 10000
uplinkA-address 0
uplinkA-address 0
uplinkA-vlan 0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
Step 9.
At the prompt, enter edit to change the port settings. The following console output is displayed.
Example
Existing uplinkA port for Boot Interface Management is port 1/1/11.
Press ENTER to keep it.
Enter the new uplinkA port number for Boot Interface Management:
Step 10. At the prompt, enter the front-panel port that is connected to the network (for example, 1/1/10).
The following console output is displayed.
Example
Enter uplinkA speed and duplex settings:
Step 11. At the prompt, enter uplink port speed and duplex settings The following console output is
displayed.
Example
Auto-Negotiation is currently disabled.
Press ENTER to proceed with existing setting or 'auto' to enable auto-negotiation.
auto
Auto-negotiation will be enabled on uplinkA port.
You need to configure the VLAN Id for this port
VLAN Id can be between 0 to 4094. To send out
packets with out any VLAN tags, type "null".
Existing VLAN Id for uplinkA port is VLAN Id 0.
Press ENTER to keep it.
Enter the new VLAN Id for uplinkA port:
Step 12. At the prompt, perform one of the following.
•
Enter null to send out packets without VLAN tags.
• Enter the a VLAN tag ID for the uplink port.
The following console output is displayed.
Example
Using port 1/1/1 as uplinkA port for Boot Interface Management
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
688
SPACER TEXT
To Next Page
Loading...