Nokia 7210 SAS-Mxp - Provisioning and Booting up the VC in Standalone Mode

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Virtual chassis
Step 2. Ensure there is console access to the CPM nodes to drive the boot process.
See the following for information: Procedure to connect to a console, 7210 SAS-S 1/10GE
console port, and 7210 SAS-Sx 10/100GE console port.
Step 3. Ensure the CPM nodes are powered on.
Step 4. Ensure that the SD card delivered with the software license containing the boot loader
(boot.tim) and TiMOS software is installed in the SD card slot.
Step 5. Manually interrupt the boot process at the boot loader BOF prompt and configure the following:
a. Specify standalone-vc for the chassis-role parameter.
b. Specify a name for the vc-stack-name parameter.
c. Specify cpm-imm for the vc-stack-node-type parameter.
d. Specify the slot number and MAC address for CPM A and CPM B in the vc-stack-node
parameter.
e. Specify the IP prefix information for the active and standby options in the eth-mgmt-address
parameter.
Step 6. Configure other BOF parameters such as image location, configuration file location, and route
information, similar to a 7210 SAS node operating in the standalone mode.
See System boot options for 7210 SAS-Mxp, 7210 SAS-S 1/10GE, 7210 SAS-Sx 1/10GE, and
7210 SAS-Sx 10/100GE in standalone mode for information.
You can get the TiMOS image (both.tim) for the CPM-IMM nodes from the local SD card or
through the network by specifying the primary/secondary/tertiary image locations appropriately.
Example
The following output is an example of a CPM-IMM node configuration.
A:Dut-A# show bof
========================================================================
BOF (Memory)
========================================================================
primary-image ftp://*:*@135.250.127.36/./images/7xxx-hops/
primary-config cf1:\default.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.17.166/24 active
eth-mgmt-address 10.135.17.167/24 standby
eth-mgmt-route 10.250.0.0/16 next-hop 10.135.17.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-name VC-3
vc-stack-node-type cpm-imm
vc-stack-node cpmA slot-num 1 mac-addr d0:99:d5:91:1c:41
vc-stack-node cpmB slot-num 2 mac-addr d0:99:d5:90:1e:41
=======================================================================
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
226
SPACER TEXT