Nokia 7210 SAS-Mxp - Provisioning Service Entities; Preprovisioning a VC

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Virtual chassis
• Specify standalone-vc for the boot loader parameter chassis-role.
• Specify a name for the boot loader parameter vc-stack-name.
• Specify cpm-imm for the boot loader parameter vc-stack-node-type.
• Specify the slot number and MAC address of each CPM-IMM node in the bof>vc-stack-node
command.
• Specify the management IP address for the active and standby CPM-IMM nodes in the
bof>eth-mgmt-address command.
• Configure the TiMOS image location.
• Configure the configuration file location.
See System boot options for 7210 SAS-Mxp, 7210 SAS-S 1/10GE, 7210 SAS-Sx 1/10GE, and
7210 SAS-Sx 10/100GE in standalone mode for information about configuring BOF parameters.
Example
The following output shows an example of a BOF configuration for a CPM-IMM node.
A:Dut-A# show bof
========================================================================
BOF (Memory)
========================================================================
primary-image ftp://*:*@135.250.127.36/./images/7xxx-hops/
primary-config cf1:\default.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 10.135.17.166/24 active
eth-mgmt-address 10.135.17.167/24 standby
eth-mgmt-route 10.250.0.0/16 next-hop 10.135.17.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-name VC-3
vc-stack-node-type cpm-imm
vc-stack-node cpmA slot-num 1 mac-addr d0:99:d5:91:1c:41
vc-stack-node cpmB slot-num 2 mac-addr d0:99:d5:90:1e:41
=======================================================================
Step 7. On the node that will be the standby CPM for the first time boot, log in through the console port
and manually interrupt the boot process.
Expected outcome
The boot prompt appears.
Step 8. Configure BOF parameters as follows:
• Specify standalone-vc for the boot loader parameter chassis-role.
• Specify a name for or the boot loader parameter vc-stack-name.
• Specify cpm-imm for the boot loader parameter vc-stack-node-type.
• Specify the slot number and MAC address of each CPM-IMM node in the bof>vc-stack-node
command.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
233
SPACER TEXT