7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
ntp-server
server ptp prefer
broadcast interface "a1"
no shutdown
----------------------------------------------
A:7210SAS>config>system>time>ntp#
6.14.1.3.5 SNTP
SNTP is a compact, client-only version of the NTP. SNTP can only receive the time from SNTP/NTP
servers; it cannot be used to provide time services to other systems. SNTP can be configured in either
broadcast or unicast client mode.
SNTP time elements include the Broadcast-client and Server-address.
Use the following CLI syntax to configure the SNTP.
config>system
time
sntp
broadcast-client
server-address ip-address [version version-number] [normal|preferred]
[interval seconds]
no shutdown
6.14.1.3.5.1 Broadcast-client
The broadcast-client command enables listening at the global device level to SNTP broadcast messages
on interfaces with broadcast client enabled.
Use the following CLI syntax to enable listening to SNTP broadcast messages at the global device level.
config>system>time>sntp
broadcast-client
Example: Command usage
The following example shows the command usage to enable listening to SNTP broadcast messages at the
global device level.
config>system>time>sntp#
config>system>time>sntp# broadcast-client
config>system>time>sntp# no shutdown
Example: Configuration output
The following is a sample configuration output of SNTP enabled with the broadcast-client command
enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
sntp
broadcast-client
no shutdown
exit
dst-zone PT
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
303
SPACER TEXT
To Next Page
Loading...