7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
broadcast
Syntax
broadcast [router router-name] {interface ip-int-name} [key-id key-id] [version version] [ttl ttl]
no broadcast [router router-name] {interface ip-int-name}
Context
config>system>time>ntp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the node to transmit NTP packets on a given interface. Broadcast and multicast
messages can easily be spoofed, thus, authentication is strongly recommended.
The no form of this command removes the address from the configuration.
Parameters
router
Specifies the router name used to transmit NTP packets. Base is the default.
Values Base, management
Default Base
ip-int-name
Specifies the local interface on which to transmit NTP broadcast packets, up to 32
characters. If the string contains special characters (#, $, spaces, and so on), the entire
string must be enclosed within double quotes.
key-id key-id
Specifies the authentication key and authentication type used by this node to receive and
transmit NTP packets to and from an NTP server and peers. If an NTP packet is received
by this node both authentication key and authentication type must be valid otherwise the
packet will be rejected and an event/trap generated.
Values 1 to 255
version version
Specifies the NTP version number that is generated by this node. This parameter does not
need to be configured when in client mode in which case all versions will be accepted.
Values 2 to 4
Default 4
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
407
SPACER TEXT
To Next Page
Loading...