Nokia 7210 SAS-Mxp - Page 408

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
ttl ttl
Specifies the IP Time To Live (TTL) value.
Values 1 to 255
broadcastclient
Syntax
broadcastclient [router router-name] {interface ip-int-name} [authenticate]
no broadcastclient [router router-name] {interface ip-int-name}
Context
config>system>time>ntp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command configures the node to receive broadcast packets on a given subnet. Broadcast and
multicast messages can easily be spoofed, thus, authentication is strongly recommended. If broadcast is
not configured then received NTP broadcast traffic will be ignored. Use the show command to view the
state of the configuration.
The no form of this command removes the address from the configuration.
Parameters
router router-name
Specifies the router name used to receive NTP packets.
Values Base, management
Default Base
interface ip-int-name
Specifies the local interface on which to receive NTP broadcast packets, up to 32
characters. If the string contains special characters (#, $, spaces, and so on), the entire
string must be enclosed within double quotes.
authenticate
Specifies whether or not to require authentication of NTP PDUs. When enabled, NTP
PDUs are authenticated upon receipt.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
408
SPACER TEXT