7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
vc-stack-mac-addr
Syntax
vc-stack-mac-addr mac-address
no vc-stack-node
Context
config>system>vc-stack
Platforms
7210 SAS-Sx 1/10GE (standalone-VC) and 7210 SAS-S 1/10GE (standalone-VC)
Description
This command configures a MAC address for a VC. This command provides an option to assign a MAC
address other than the chassis MAC belonging to the CPM-A node. By assigning the MAC address instead
of using the chassis MAC address belonging to the CPM-A node, operators do not need to change the
MAC address when the CPM-A card is physically replaced with another card.
The no form of this command reverts the value to the default MAC address specified in the BOF.
Parameters
mac-address
Specifies the MAC address of the VC.
6.20.2.1.4 System alarm commands
thresholds
Syntax
thresholds
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
Commands in this context configure monitoring thresholds.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
374
SPACER TEXT
To Next Page
Loading...