Nokia 7210 SAS-Mxp - USB Storage Device

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
id 1 to 200
qtag1 0 to 4094
qtag2 *, 0 to 4094
dlci 16 to 022
port-id
Specifies the physical port ID in the slot/mda/port format.
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id must be
in the slot_number/MDA_number/port_number format. For example 1/2/3 specifies port 3
on MDA 2 in slot 1.
qtag1, qtag2
Specifies the encapsulation value used to identify the SAP on the port or sub-port. If this
parameter is not specifically defined, the default value is 0.
The values depends on the encapsulation type configured for the interface. The following
table describes the allowed values for the port and encapsulation types.
Table 15: Allowed values for port and encapsulation types
Port type Encap-type Allowed values Comments
Ethernet Null 0 The SAP is identified by the port.
Ethernet Dot1q 0 to 4094 The SAP is identified by the 802.1Q tag on the
port. A 0 qtag1 value also accepts untagged
packets on the dot1q port.
Ethernet QinQ qtag1: 0 to 4094
qtag2: 0 to 4094
The SAP is identified by two 802.1Q tags on
the port. A 0 qtag1 value also accepts untagged
packets on the dot1q port.
Values qtag1: 0 to 4094
qtag2 : * | 0 to 4094
interval seconds
Specifies the interval for each display in seconds.
Default 11 seconds
Values 11 to 60
repeat repeat
Specifies how many times the command is repeated.
Default 10
Values 1 to 999
absolute
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
91
SPACER TEXT