7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================
*A:dut-b>show#
4.11.3 Common configuration tasks
This section describes basic system configuration tasks that must be performed to configure the BOF.
For details about hardware installation and initial router connections, see the specific hardware installation
guide.
4.11.3.1 Searching for the BOF
The BOF should be on the same drive as the bootstrap image file. If the system cannot load or cannot find
the BOF, the system checks whether the boot sequence was manually interrupted or else continues with
the auto-init mode. The system prompts for a different image and configuration location.
Note:
Auto-init is not supported on the 7210 SAS-R6 and 7210 SAS-R12; use the starter BOF or create
a BOF manually to boot the system.
4.11.3.2 Sample output of BOF configuration on bootup for 7210 SAS platforms
This section provides sample output of a BOF configuration boot sequence for 7210 SAS platforms.
4.11.3.2.1 Sample output: BOF configuration on bootup for 7210 SAS-Mxp and 7210 SAS-T
Example
The following is a sample output of a manually interrupted boot sequence on the 7210 SAS-Mxp and
7210 SAS-T.
Hit a key within 3 seconds to change boot parameters...
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"reset" - reset the bof and reboot.
Press ENTER to begin, or 'flash' to enter firmware update, or the shell password...
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
155
SPACER TEXT
To Next Page
Loading...