Nokia 7210 SAS-Mxp - System Resource-Profile Router Commands for 7210 SAS-M, 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx 1;10 GE, and 7210 SAS-Sx 10;100 GE; System Resource-Profile Commands Related to BGP LU FRR and Ldporsvp FRR for 7210 SAS-M, 7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx 1;10 GE, and 7210 SAS-Sx 10;100 GE

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
memory-use-warn
Syntax
memory-use-warn rising-threshold threshold [falling-threshold threshold] interval seconds [rmon-
event-type] [startup-alarm alarm-type]
no memory-use-warn
Context
config>system>thresholds
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
The memory thresholds are based on monitoring MemoryUsed object. This object contains the amount of
memory currently used by the system. The severity level is Alarm.
The absolute sample type method is used.
The no form of this command removes the configured compact flash threshold warning.
Parameters
rising-threshold threshold
Specifies a threshold for the sampled statistic. A single threshold crossing event is
generated when the current sampled value is greater than or equal to this threshold, and
the value at the last sampling interval was less than this threshold. A single threshold
crossing event will also be generated if the first sample taken is greater than or equal to
this threshold and the associated startup-alarm is equal to rising or either.
After a rising threshold crossing event is generated, another such event will not be
generated until the sampled value falls below this threshold and reaches less than or equal
the falling-threshold value.
Default 0
Values –2147483648 to 2147483647
falling-threshold threshold
Specifies a threshold for the sampled statistic. A single threshold crossing event is
generated when the current sampled value is less than or equal to this threshold, and
the value at the last sampling interval was greater than this threshold. A single threshold
crossing event will also be generated if the first sample taken is less than or equal to this
threshold and the associated startup-alarm is equal to falling or either.
After a rising threshold crossing event is generated, another such event will not be
generated until the sampled value raises above this threshold and reaches greater than or
equal the rising-threshold value.
Default 0
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
384
SPACER TEXT