Nokia 7210 SAS-Mxp - Page 90

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
When the keyword rate is specified, the ‟rate per second” for each statistic is displayed instead of the
delta.
Monitor commands are similar to rate commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
service-id
Specifies the unique service identification number of the service in the service domain.
sap
Syntax
sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context
monitor>service>id
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command monitors statistics for a SAP associated with this service.
This command displays statistics for a specific SAP, identified by the port-id and encapsulation value, at the
configured interval until the configured count is reached.
The first screen displays the current statistics related to the SAP. The subsequent statistical information
listed for each interval is displayed as a delta to the previous display. When the keyword rate is specified,
the rate per second for each statistic is displayed instead of the delta.
Monitor commands are similar to rate commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
sap-id
Specifies the physical port identifier portion of the SAP definition.
Values sap-id: null [port-id | lag-id]
dot1q [port-id | lag-id]:* | qtag
qinq [port-id | lag-id]:qtag1.qtag2
port-id slot/mda/port
lag-id lag-id
lag keyword
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
90
SPACER TEXT