7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Getting started
1 Getting started
This chapter provides an overview of the document organization and content, and describes the
terminology used in this guide.
1.1 About this guide
Note:
Unless explicitly noted otherwise, this guide uses 7210 SAS-Dxp to refer to the 7210 SAS-Dxp
12p, 7210 SAS-Dxp 16p, and 7210 SAS-Dxp 24p platforms.
This guide describes system concepts and provides configuration examples to configure the boot option
file (BOF) on the following 7210 SAS platforms, operating in one of the modes described in Table 1:
Supported modes of operation and configuration methods. If multiple modes of operation apply, they are
explicitly noted in the topic.
• 7210 SAS-Mxp
• 7210 SAS-R6
• 7210 SAS-R12
• 7210 SAS-Sx/S 1/10GE
• 7210 SAS-Sx 10/100GE
• 7210 SAS-T
See 7210 SAS modes of operation for information about the modes of operation supported by the
7210 SAS product family.
Note:
Unless explicitly noted otherwise, the phrase ‟Supported on all 7210 SAS platforms as described
in this document” is used to indicate that the topic and CLI commands apply to all the 7210 SAS
platforms in the following list, when operating in the specified modes only.
• network mode of operation
7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx
10/100GE, and 7210 SAS-T
• standalone mode of operation
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE
• standalone-VC mode of operation
7210 SAS-Sx/S 1/10GE
If the topic and CLI commands are supported on the 7210 SAS-T operating in the access-uplink
mode, it is explicitly indicated, where applicable.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
20
SPACER TEXT
To Next Page
Loading...