Nokia 7210 SAS-Mxp - Page 73

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
more
Syntax
[no] more
Context
environment
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command enables per-screen CLI output, meaning that the output is displayed on a screen-by-screen
basis. The terminal screen length can be modified with the terminal command. The following prompt
appears at the end of each screen of paginated output:
Press any key to continue (Q to quit)
The no form of the command displays the output all at once. If the output length is longer than one screen,
the entire output will be displayed, which may scroll the screen.
Default
more
reduced-prompt
Syntax
reduced-prompt [no of nodes in prompt]
no reduced-prompt
Context
environment
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command configures the maximum number of higher CLI context levels to display in the CLI prompt
for the current CLI session. This command is useful when configuring features that are several node levels
deep, causing the CLI prompt to become too long. By default, the CLI prompt displays the system name
and the complete context in the CLI.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
73
SPACER TEXT