7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
name
Syntax
name system-name
no name
Context
config>system
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command creates a system name string for the device.
For example, system-name parameter ALA-1 for the name command configures the device name as
ALA-1.
Only one system name can be configured. If multiple system names are configured, the last one
encountered overwrites the previous entry.
The no form of this command reverts to the default value.
Default
the default system name is set to the chassis serial number which is read from the backplane EEPROM
Parameters
system-name
Specifies the system name as a character string. The string may be up to 32 characters.
Any printable, seven-bit ASCII characters can be used within the string. If the string
contains special characters (#, $, spaces, and so on), the entire string must be enclosed
within double quotes.
oper-group
Syntax
oper-group name [create]
no oper-group name
Context
config>system
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
361
SPACER TEXT
To Next Page
Loading...