7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Port 1/1/67, Speed:100000, Duplex:Full, Link:Up.
DHCP Server:192.168.2.8
Boot device addr: 192.168.2.9
Subnet mask: 24
Boot host: 192.168.2.8
Url from Boot file: tftp://192.168.2.8/images-pf/SASS/voy/bof.cfg
Initial DNS resolving preference is ipv4-only
Step 4. The DHCP server responds to the system request and supplies an IP address, default gateway
information, and a BOF location.
The following console output is displayed.
Looking for tftp://192.168.2.8/images-pf/SASS/voy/bof.cfg ... OK, reading
Successfully saved the new settings in cf1:/bof.cfg
Step 5. The system applies the IP configuration and downloads the BOF from the location specified by
the DHCP server. The BOF is saved on the flash drive.
The 7210 SAS device initiates the boot using the BOF, and the following console output is
displayed.
Example
My New Settings
------------
primary-image ftp://*:*@192.168.2.8/./images-pf/SASS/voy/hops-both.tim
primary-config ftp://*:*@192.168.2.8/./images-pf/SASS/voy/dut-h.cfg
#eth-mgmt Port Settings:
no eth-mgmt-disabled
eth-mgmt-address 192.168.2.9/24 active
eth-mgmt-route 192.250.0.0/16 next-hop 192.168.2.8
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
host-type standalone
Setting the chassis role to standalone.
Configuring Network with eth-mgmt Port Setting.....
Primary config file location: ftp://*:*@192.168.2.8/./images-pf/SASS/voy/dut-h.cfg
Initial DNS resolving preference is ipv4-only
Downloading 'ftp://*:*@192.168.2.8/./images-pf/SASS/voy/dut-h.cfg'...OK
Sap Index file location: ftp://*:*@192.168.2.8/./images-pf/SASS/voy/dut-h.sdx
Downloading 'ftp://*:*@192.168.2.8/./images-pf/SASS/voy/dut-h.sdx'...OK
Primary image location: ftp://*:*@192.168.2.8/./images-pf/SASS/voy/hops-both.tim
Initial DNS resolving preference is ipv4-only
Loading image ftp://*:*@192.168.2.8/./images-pf/SASS/voy/hops-both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312)
Step 6. After the 7210 SAS device boots up, the following login prompt is displayed.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
679
SPACER TEXT
To Next Page
Loading...