7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Appendix: 7210 SAS boot
procedures
Executing TiMOS image at 0x60100000
Step 20. After the 7210 SAS device boots up, the following login prompt is displayed.
Example
All rights reserved. All use subject to applicable license agreements.
Built on Wed Apr 20 22:44:35 IST 2011 by builder in /builder/3.0B5/R4/panos/main
Login:
Step 21.
At the prompt, enter admin for the default username and password, and log into the 7210 SAS
device.
Example
Note:
The Sys LED is green when the device has successfully completed the boot process
and is running normally.
7.2.3 Procedure to boot from the network in manual mode using the OOB Ethernet
management port
About this task
Note:
This procedure is not supported for 7210 SAS platforms configured in the satellite mode of
operation. This procedure is supported on all 7210 SAS platforms that are equipped with an OOB
Ethernet management port.
Perform the following steps to boot from the network using the OOB Ethernet management port without
using the auto-init mode.
Procedure
Step 1. Power on the 7210 SAS device.
Step 2. Use the OOB Ethernet Management port to boot from the network.
Example
Nokia 7xxx Boot ROM. Copyright 2000-2020 Nokia.
All rights reserved. All use is subject to applicable license agreements.
Build: X-20.3.B1-1 on Wed Feb 12 15:29:52 IST 2020 by sasbuild
Version: 0x38
Processor core is CN66xx
COLD boot on processor #1
?Preparing for jump to RAM...
Starting bootrom RAM code...
Boot rom version is v56
CPU #1 booted from working sector
CPU Control FPGA version is 0x3D
FPGA A version is 0x3D. FPGA B version is 0x3D. FPGA C version is 0x3D.
Restart type = 0x01
>>>Validate SDRAM from 0x000000007fdfff80 to 0x0000000080000000 (decrementing)
>>>Testing SDRAM from 0x0000000002200000 to 0x000000007fdfff80
>>>Testing SDRAM from 0xffffffffe0000000 to 0xffffffffe2000000
Power on Diagnostics passed
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
691
SPACER TEXT