Nokia 7210 SAS-Mxp - Page 184

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Note:
• Nokia strongly recommends that you should not rename the cf1:\boot.tim and cf1:\both.tim
files. These files should be retained in case the system needs them during the password
recovery procedure. Nokia also recommends making a backup of all the image files,
configuration files, and other data.
• Enabling or disabling the secure-bof-password command resets the BOF password to the
default password. See secure-bof-password for more information.
The no form of this command deletes the configured password and resets to the default password. The no
form is supported only when secure-bof-password enable is configured.
Default
bof password password
Parameters
password
Specifies the BOF password in plaintext string format, between 8 and 32 characters.
console-disabled
Syntax
[no] console-disabled
Context
bof
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command allows the user to enable or disable the serial port console for use.
In remote deployments, this command provides additional security mechanism for the user. The console
can be disabled to prevent unauthorized system access.
Note:
The console is always available for use when the device is booting up. This command is
applicable only after the TiMOS image (both.tim) is up and running successfully. If the user
executes this command in the BOF CLI context, the command takes effect only during the next
boot. A BOF save operation must be performed after executing the console-disabled command.
The no form of this command enables the console.
Default
no console-disabled
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
184
SPACER TEXT